Instructions for use
1, Please install ANT (must be DONE) before debugging or testing VTX（and OSD）, or lead to VTX not working properly.
2, Please use proper tools to install FlyTower .It is easy to damage the PCB components by using sharp tools. (warning: Bear in mind that screws do not install too tight between every layer, so as not to destroy the PCB and electronic components).
3,When debugging and testing flight control Please remove all the propeller; Try not to test indoors, So as not to cause safety accidents. Install the propeller before a test flight, please check again.
4,Please check and adjust ESC plate welding, thus brings all the losses and problems, or you should face the consequences.
5,Please do not fly your drone near the crowd, for all the losses from the crashed aircraft, you should face the consequences.
6,For your safety, please do not use more than 4s battery, Using more than 4s battery would cause safety risk, we will not undertake any responsibility.
7, Before power on, please check the positive and negative pole again to make sure whether there is a short circuit .( you also have to check that whether there is a short circuit between your motor cables and you drone’s body).
8,Please use original screws and fixings to install FlyTower.
1 x 4 in 1 40A ESC BLHeli_S
1 x F3 flight controller & 48CH VTX
F3 flight controller & 48CH VTX: Board firmware version: Betaflight 3.1.7 OMNIBUS Configure: Betaflight VTX power: OFF/25/200/400mW (MAX 800mW) CH: 48CH OSD firmware: Betaflight OSD Video camera voltage: any stand by 5V video camera Board size: 36*36mm Weight: 11.4g
4 in 1 40A ESC BLHeli_S: PDB: integrated Battery monitoring: integrated power: integrated Operating voltage: 2-4S Lipo Maximum continuous operating current: 4*40A Maximum instantaneous operating current: 4*45A(5 Seconds) Oneshot 125/42/ Dshot 150/300/600: YES BlheliSuite configurable: YES Firmware version: BLHeli_S / Dshot 150/300/600 16.6(A_H_15/L_H_0)
Flytower F3 PRO: Any board weight: 21.4g Total weight: 28.7g Installation height(Add air-cooling fin): 15mm/20mm Screws: M3*18mm Recommended rack plate thickness: not more than 3mm (3mm above the appropriate extension of the screw)
The flytower PRo F3/F4 board was designed basing on Omnibus/omnibusF4SD(Betaflight) FC and highly integrated with OSD, BEC, 4 in 1 BLHeli_S / Dshot 600ESC and VTX with audio ( OFF / 25/200/400 mW). It gives you al the features what you need in FPV, which make you easily get into FPV racing.
Package included: 1 x 4 in 1 40A ESC BLHeli_S 1 ;x F3 flight controller & 48CH VTX
Frequently Bought Together
Frsky XM Plus Mini Full Range Receiver Failsafe D16 Mode Support SBUS Up Compatible With Frsky X9D / X9D Plus X9E X12S Transmitter.$17.99
Tattu 4S 1300mAh LiPo Battery 75C 14.8V Pack with XT60 Plug for RC Boat Heli Airplane UAV Drone FPV Skylark Emax Nighthawk 250$28.99
16pcs Gemfan Flash 2540 3-Blade Propeller 2.5inch Triblade Props Compatible with 1105 1106 Brushless Motor for DIY Micro FPV Drone Quadcopter (Black)$9.99